InterfaceOperMode

class ydk.models.cisco_ios_xe.CISCO_ST_TC.InterfaceOperMode

InterfaceOperMode (Enum Class)

Represents the operational mode of an interface

auto (1) - Mode is determined by port initialization

scheme.

fPort (2) - Fibre channel fabric port.

flPort (3) - Fibre channel arbitrated loop port.

ePort (4) - Fabric Expansion port.

bPort (5) - Bridging port.

fxPort (6) - This port can only be f_port or fl_port.

sdPort (7) - SPAN destination port. SD_ports transmit

traffic copied from one or more source

ports for monitoring purposes.

tlPort (8) - Translation loop port.

nPort (9) - Fibre channel N port.

nlPort (10) - Fibre channel NL port.

nxPort (11) - This port can only be n_port or nl_port.

– read only port types.

tePort (12) - Trunking e_port.

Note: A port which is administratively set

to ‘ePort’, will operationally have type

‘tePort’ if fcIfOperTrunkMode has the value

‘trunk’.

fvPort (13) - Virtual Port.

portOperDown (14) - port operationally down

If a port is operationally down, the

port mode is unknown. In such cases

the operational port mode is shown

as ‘portOperDown’.

stPort (15) - SPAN Tunnel destination port.

mgmtPort(16) - Mgmt Port.

ipsPort(17) - Ethernet Port.

evPort(18) - FCIP tunnels on Ethernet ports.

npPort (19) - N Proxy port mode applicable only

to N-port Virtualizer (NPV).

tfPort (20) - Trunking fibre channel fabric port.

tnpPort (21) - Trunking N Proxy port mode applicable only

to N-port Virtualizer (NPV).
auto = 1
fPort = 2
flPort = 3
ePort = 4
bPort = 5
fxPort = 6
sdPort = 7
tlPort = 8
nPort = 9
nlPort = 10
nxPort = 11
tePort = 12
fvPort = 13
portOperDown = 14
stPort = 15
mgmtPort = 16
ipsPort = 17
evPort = 18
npPort = 19
tfPort = 20
tnpPort = 21