IFMIB

Children

class ydk.models.cisco_ios_xe.IF_MIB.IFMIB

Bases: Entity

Class Hierarchy : IFMIB

This class represents state data.

interfaces

type: Interfaces

config: False

ifmibobjects

type: IfMIBObjects

config: False

iftable

A list of interface entries. The number of entries is given by the value of ifNumber

type: IfTable

config: False

ifstacktable

The table containing information on the relationships between the multiple sub-layers of network interfaces. In particular, it contains information on which sub-layers run ‘on top of’ which other sub-layers, where each sub-layer corresponds to a conceptual row in the ifTable. For example, when the sub-layer with ifIndex value x runs over the sub-layer with ifIndex value y, then this table contains: ifStackStatus.x.y=active For each ifIndex value, I, which identifies an active interface, there are always at least two instantiated rows in this table associated with I. For one of these rows, I is the value of ifStackHigherLayer; for the other, I is the value of ifStackLowerLayer. (If I is not involved in multiplexing, then these are the only two rows associated with I.) For example, two rows exist even for an interface which has no others stacked on top or below it: ifStackStatus.0.x=active ifStackStatus.x.0=active

type: IfStackTable

config: False

ifrcvaddresstable

This table contains an entry for each address (broadcast, multicast, or uni-cast) for which the system will receive packets/frames on a particular interface, except as follows: - for an interface operating in promiscuous mode, entries are only required for those addresses for which the system would receive frames were it not operating in promiscuous mode. - for 802.5 functional addresses, only one entry is required, for the address which has the functional address bit ANDed with the bit mask of all functional addresses for which the interface will accept frames. A system is normally able to use any unicast address which corresponds to an entry in this table as a source address

type: IfRcvAddressTable

config: False